|
|
|
 |
|
 |
|
|
|
|
|
 |
|
|
|
 Introduction
|
CLAN-AMP is two-way AMP that compensates
Loss occured from cable between AstroGate
and AiroEdge, and it has AGC (Automatic
Gain Control) function of sending standardized
output regardless of inputted signal.
It's inputting Range is -65dBm ~ -20dBm
of Rx port, and it is able to output standardized
signal of maximum 10dBm due to the Automatic
Gain Control Algorithm.
|
|
|
Function
|
- Perfectly compensates
the Loss of maximum 200M cable
It perfectly compensates the Loss of up
to 200M coaxial cable (-20dB/100M standard)
beween CLAN-AMP and CLAN-AMP. But, Loss
can be differed due to a kind of cable.
- Supports stable output
Even though the signal from AstroGate
attenuated due to the cable Loss, it can
maintain the standardized output value
using AGC function regardless of attenuation.
- Accommodate large inputting range
It accommodates large inputting range
of -55dBm ~ -20dBm at Rx port.
- Easy installation
In case of attenuation occur due to the
various reason betwenn AstroGate and AiroEdge,
it could provides extended Coaxial LAN
service by simply installing CLAN-AMP
to existing CATV cable. See the below
for the details on installation.
- Check TX/RX status through LED
We can check the connection status through
TX/RX LED of CLAN-AMP.
- DB conditioning function using ATT
CLAN-AMP can set up 0~31 dB because it
has Attenuator conditioning function,
therefore there is no need to install
extra Attenuator at the IN/OUTPUT port.
- It has Diplxer within,
therefore it can be connected with CATV-AMP
without splitter.
Because it has Diplxer within, the connection
with CATV-AMP is much more easier and
convenient.
- It can be installed
at anywhere becasue of it's small size
and powerful function.
(Small size and powerful function)
It's small size (Compactable) made installation
much more convenient.
|
|
|
Specification
|
General
|
|
Model Name |
CLAN-AMP
|
|
Stream Port |
CLAN 1 Channel support |
|
Wired Network Architecture |
Ethernet ( 10/100Mbps ) |
|
Power |
90~265VAC, 47/63Hz to 5V DC 2A |
|
RF Specification
|
|
Center Frequency |
937MHz (+/- 25MHz) |
|
Input Power Level |
Typical -65~-20dBm (-17~28dBmV) |
|
Flatness@-50dBm, Input |
< 2.0 dB |
|
Gain |
40dB |
|
Minimum AGC Input Signal @900MHz |
Typical -65dBm (-17dBmV / 43dBuV) |
|
Maximum AGC Input Signal @900MHz |
Typical -20dBm (28dBmV/88dBuV/) |
|
VSWR (Max) |
2.0 : 1 |
|
Input/Output Impedance |
75 §Ù (F-type connector) |
|
Environmental Information
|
|
Operating Temperature |
-20 ¡É to 70¡É |
|
Storage Temperature |
-25 ¡É to 90¡É |
| Humidity |
95% Non-condensing |
|
Physical Characteristics
|
|
LED Indicator |
TX, RX, Power |
|
Dimension |
|
|
Weight |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
